GE / IP FANUC Series 90/30 In Stock

Call Now

1-800-360-6802

Mon-Fri 8AM-5PM EST

1-919-535-3180

IC687BEM744

Rated 0/5 Based on ratings.

Rate your purchase of the IC687BEM744

GE Intelligent Platforms / GE Fanuc - RX7i PacSystem - IC687BEM744 | Image

GE Intelligent Platforms / GE Fanuc - RX7i PacSystem - IC687BEM744 | Image GE Intelligent Platforms / GE Fanuc - RX7i PacSystem - IC687BEM744 - Wiring

SKU 0  UPC 00

MSRP $15995

New

$12995

2 In Stock

2 Year warranty

*Need a
Specific Revision?

Reman

$5995

1 In Stock

2 Year warranty

*What is
Remanufactured?

Order Today - Ships Today!


*US continental orders placed before 4:30pm EST!

The IC687BEM744 is a FIP Bus Controller designed specifically for the IC967 family of PLCs manufactured by GE Fanuc. It is one of four compatible FIP Bus Controllers and is a half-slot module. Because the module’s architecture has a half-width faceplate, it is perfect for installation in an integrated rack. This half-slot module is functionally identical to a full-slot FBC.The IC687BEM744 should be used with a 2.5MHz WorldFIP network. Like the other four FIP Bus Controllers, the IC687BEM744 allow for TCP/IP communications in addition to generic messaging compatibility and support. Please note, FIP Bus Controllers, such as the IC687BEM744, cannot be installed in a PLC expansion rack in a 90-70 PLC system. However, a single 90-70 PLC system can support up to four FIP Bus controllers.

The IC687BEM744 is equipped with 6 LED’s to indicate status, a 15-pin serial connector RS-485 port, two 9-pin FIP Fieldbus connector channels, and a restart button. The 6 LED’s represent the following, from top to bottom: Module OK, Bus Arbiter, Carrier Detect Ch. 1, Transmit Enable Ch. 1, Carrier Detect Ch. 2, and Transmit Enable Ch. 2. The RS-485 port is used to easily connect your PC to the module for upgrading firmware. The restart button allows the user to restart the module or to reload software while simultaneously restarting the module. The two FIP Bus Connectors allows the IC687BEM744 to support redundant bus capabilities. It is important to never install or remove the module when power is applied to the system.

PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.

TOP