GE / IP FANUC Series 90/30 In Stock
SKU 2173226 UPC 0799705798304
All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.
The 1771-DL is a Gray Code Converter from Allen Bradley. The 1771-DL has 15 mA per bit at 27 DC and a 6 mA per bit at 10 Volts DC on an input sourcing current. This module is powered by a 12 or 24 Volt DC power source, which is attached between the absolute encoder and the 1771-WB wiring arm. The zero speed triac switch is turned on when the encoder is moving, and will turn off when the 1771-DL gray code converter module has sensed the motion and has stopped and on a selectable time. The 845A-SJZ3DN6DW, which is an 8-bit gray encoder bulletin, is compatible with the 1771-DL module. The PLC controller uses an 8 bit input, which is sourced from the 8-bit grey code and converted to an 8-bit binary number. The time delay of the 1771-DL can be set to between 6 and 0.3 seconds using the trim lock (knob) on the face of the module. This is done by turning the counter knob either clockwise or counterclockwise to increase and decrease the delay respectively. This knob also acts as a safety-interlock, which can be used to open the drive circuit when an encoder failure occurs. The 1771-DL module is rated for operation at temperatures not exceeding 60 degrees Celsius and not below 0 degrees Celsius. This module should be stored within temperatures that ranging from -40 to +85 degrees Celsius and has an off-state maximum current leakage of 5mA, along with an on-state voltage drop of 2 Volts and a load current of 100mA. The 1771-DL communicates with a processor through the backplane, where it provides 8-bit 0-255 binary of output data to the processor.
PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.