GE / IP FANUC Series 90/30 In Stock
Notice: By clicking this link, you will be redirected away from PDFsupply.com to DOsupply.com
The Allen Bradley 1747-SDN is DeviceNet scanner module. It is compatible with the SLC-5/02, SLC-5/03, SLC-5/04, and SLC-5/05 processors of the SLC 500 series. The 1747-SDN DeviceNet scanner module lets you connect low-level devices straight to the plant floor. The need of incorporating an I/O interface device is eliminated. The 1747-SDN DeviceNet scanner module provides extra diagnostic features which enhance data collection and/or fault detection. Moreover, with the 1747-SDN, less wiring than usual is required.
The 1747-SDN facilitates communication with a maximum of 63 DeviceNet-compatible I/O devices. The 1747-SDN module holds a maximum of 150 words of input and a maximum of 150 words of output data. It supports all standard DeviceNet communication rates, exchange of status, and configuration data.
The 1747-SDN draws a backplane current of 500mA at 5V DC and it has a network power source of 90mA at 24V DC. It has a communication rate of 125Kbps, 250Kbps, and 500Kbps at 24V DC. Its isolation voltage is tested at 500V AC for 60 seconds and its DeviceNet-to-backplane isolation voltage is 24V. The 1747-SDN has a minimum thermal dissipation of 2.50W and a maximum of 2.5W.
The 1747-SDN is programmed and communicates with the processor using the M0 and M1 data files that reside in the module. Generally, the 1747-SDN interfaces DeviceNet devices with SLC-5/02 or higher processors. Over the network, the 1747-SDN reads and or writes data to DeviceNet devices, downloads configuration data, and monitors the operational status of devices. The 1747-SDN can be used as a bridge between a DeviceNet network with other networks.
The 1747-SDN gets or delivers data to or from devices using poll, strobe, change-of-state, and cyclic messages. To connect the 1747-SDN module to the device network: 1. Turn off the network power supply. 2. Connect the DeviceNet drop line to the 10-pin linear plug (match the color insulation tables). 3. Insert the 10-pin linear plug into the DeviceNet connector located on the front side.
PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.