1-919-535-3180 | 1-800-360-6802
sales@pdfsupply.com

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

1-919-535-3180

1-800-360-6802

Mon-Fri 8AM-5PM EST

sales@pdfsupply.com

IC755ACC07GAS

Rated 4.6/5 Based on 7 ratings.

Rate your purchase of the IC755ACC07GAS

GE Quickpanel Gasket Kit Replacement IC755 ACC07GAS | Image

GE Quickpanel Gasket Kit Replacement IC755 ACC07GAS | Image GE Fanuc PLC - QuickPanel - IC755ACC07GAS - Wiring

SKU 0  UPC 00

Submit RFQ for IC755ACC07GAS





Other Available Revisions for the IC755ACC07GAS ABCDEFGHIJKLMNOPQRSTUVWXYZ

Common misspellings:
  • 1C755ACC07GAS
  • lC755ACC07GAS
  • IC755ACCo7GAS
  • IC755ACC07GAS

GE Quickpanel Gasket Kit Replacement IC755 ACC07GAS

Technical Information

The IC755ACC07GAS gasket is a replacement gasket manufactured by GE Fanuc in the QuickPanel series as a replacement gasket for most of the QuickPanel Plus series devices. It is part of the intelligent division platform of the QuickPanel Plus series as an accessory. This gasket is designed to replace the old version of the QuickPanel Plus gasket module because the original version had a preinstalled module that the new version does not. Due to continuous wear and tear during operation, the gasket on a terminal needs to be replaced. The GE Fanuc IC755ACC07GAS replacement gasket comes with 4 holes on the top and bottom to secure the device to a mounting surface. It is recommended that the mounting clips be tightened occasionally and to avoid the frequent removal or insertion of the terminal to prevent the gasket and the mounting clips from wearing out sooner than normal.

 

No cable is required to be connected to the terminal during the installation of the IC755ACC07GAS replacement gasket for a QuickPanel Plus device. It will not fit into the gasket if any cables are attached. The power supply of the terminal must be disconnected during the installation time. After disconnecting the power supply, the users need to verify and countercheck if the replacement gasket for the terminal is located in the bezel channel on the sides of the device. To properly secure the device, it is advisable to use a torque range of 0.3 N-m on the mounting hardware that holds it in place. All the terminals that are compatible with the GE Fanuc IC755ACC07GAS replacement gasket can operate within a temperature range of 0 to 50 degrees Celsius.

ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.