GE / IP FANUC Series 90/30 In Stock
1-919-535-3180
1-800-360-6802
Mon-Fri 8AM-5PM EST
IC694ALG391-Wiring
SKU 2178264 UPC 0799705802407
All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.
Product Description
The GE Fanuc IC694ALG391 is a two channel analog current output module. Each of the two channels is capable of converting 12 bits of binary data for field devices. Additionally, each output can be set up using a jumper to construct varying signals, 0 to 20 mA or 4 to 20 mA. Each output can be set as a less exact voltage source, and the range is made with a jumper or resistor on the terminals as decided by the user.
Though an external source of isolated +24 VDC is vital for power for the module, it can be linked via the TB1 connector on the backside or directly to the terminal block. Both are effective methods for this model. However, if the user needs to preserve hold last state operation during a loss of backplane power, then an outside source is needed. An update rate of 5 milliseconds on both channels is application dependent but available.
When installing the GE Fanuc IC694ALG391, a good grade of twisted, shielded instrumentation cable should be used to lessen noise and capacitive loading. Each channel’s range is set with jumpers on the module terminals, and for voltage operation, a 250 Ohm resistor can be used in place of a voltage jumper if desired. Note: If the output default jumper is installed on module terminals 11 and 13, then both outputs will default, using the low end of their range. If the output jumper is not installed, both outputs will hold the last valid output value that was acknowledged. However, this route requires an external +24 VDC power supply.
Technical Specifications
| No. of channels: | 2 |
| Voltage Range: | 1-5 V, 0-5 V |
| Current Range: | 0-20 mA, 4-20 mA |
| Update Rate: | 5 msec |
| Output Load: | 5 mA max |
| Power Consumption: | 30 mA @ +5VDC, 120 mA @ +24VDC Isolated |
Common related search terms: Battery, Buy, Configuration, Datasheet, Dimension, Fanuc, Firmware, GE, GE-Fanuc, Manual, PDF, PLC, Price, Repair, Specification, Troubleshoot, User-Manual, Wiring,
Adding Items to Cart
PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.