GE / IP FANUC Series 90/30 In Stock
SKU 2177169 UPC 0847375413215
All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.
The IC698CHS217 is a rear-mounted, rear I/O access module rack from GE Automation and Controls. With a total capacity of 17 slots, this rack is capable of accommodating a variety of RX7i CPUs, Series 90-70 modules, and VME devices. Both single and double width devices are supported. Note: Slot zero is reserved for the power supply, and slot one is designated for the CPU. The spacing between each module is 0.8 inches apart (20.3mm). To allow rear access to the I/O pins, an offset bracket is used.
This rack comes with several features such as rear access to backplane modules and support for an optional cooling fan. The IC698CHS217 uses slot sensing for module addressing, so jumpers and DIP switches are not needed. VME64 J2 connectors on the backplane have transfer speeds of 64 bits every cycle. RX7i plug in power supplies are also supported and have the ability to carry higher wattage.
The IC698CHS217 is classified as open equipment; as such, it must be installed in an environment rated IP54 or better. Overall, this rack is 11.15 inches high (283mm), 19 inches wide (483mm), and 8.875 inches deep (225mm). With the rear-mounted cover installed, the height and width remain the same, but the depth changes to 8.97 inches (228mm). M6 machine screws are needed for mounting the IC698CHS217 with rack spacers. If a fan is to be installed, 9 inches (23cm) of additional clearance is needed.
To shield ground RX7i and Series 90-70 modules, ensure all devices are screwed directly to the rack. Some modules also have a grounding clip attached that grounds the device when fully inserted into the rack. To safety ground the modules, connect the studs on the side of the rack to the earth ground using the proper wire.
|Module Type:||Standard Rack|
|Number of Slots:||17 Single Width, 8 Double Width|
|Rack Slot Size:||0.8 inch|
|Dimensions:||11.15 x 19.0 x 8.875 in. (H x W x D)|
|Power Supply:||RX7i Power Supply in Slot 0|
PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.