GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

Mon-Fri 8AM-5PM EST



Rated 4.3/5 Based on 4 ratings.

Rate your purchase of the IC693ACC335
GE Fanuc PLC - Series 90-30 - IC693ACC335

SKU 2170411  UPC 0799705806634

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to in indicate any affiliation with or authorization by any rights holder.

PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.

The GE Fanuc IC693ACC335 is a digital servo axis terminal board. This board connects DSM connector A or B to a GE Fanuc α or β Digital Servo amplifier. It also provides screw terminal connections for I/O devices. The IC693ACC335 contains two connectors, both of which have 36 pins. One of these is labelled DSM and connects to the DSM via a cable (IC693CBL324/325) while the other, labelled SERVO, connects to the GE Fanuc Digital Servo amplifier.  This is done through the servo command cables (IC800CBL001 / 002). If a Digital Servo Axis does not need to use any devices that normally connect to the IC693ACC335 Digital Servo Terminal Board screw terminals, then neither the Terminal Board nor Terminal Board Cable IC693CBL324/325 will be needed.

In this case, it is possible to connect the Digital Servo Command Cable directly from the Digital Servo Amplifier to the DSM302 faceplate – through either the A or B connector. When doing this, it’s important to configure the OT Limit Sw parameter correctly. It must be set to DISABLE or else the DSM will not operate. If this terminal board is not being used to break out user I/O points such as home limit inputs, then the other end of the cable should be inserted differently on the front of the DSM302. Insert it into connector A for servo axis 1, or else connector B for servo axis 2.

ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

Common related search terms: Emerson


PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.