World's Largest Warehouse of
GE 90-30, Genius, and RX7i

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i



Mon-Fri 8AM-5PM EST


Rated 4.2/5 Based on 9 ratings.

Rate your purchase of the IC697ACC621

GE Intelligent Platforms / GE Fanuc - Series 90-70 - IC697ACC621

GE Intelligent Platforms / GE Fanuc - Series 90-70 - IC697ACC621 IC697ACC621 | Image

SKU 0  UPC 00

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.

MSRP $1250

"Best Value"

Surplus New


Save $355

1 in stock

✓  3 Year warranty

*What is Surplus New?

Free Ground Shipping*

US continental orders placed Monday-Friday before 4:30pm EST!

Lowest Price Guarantee

Product Description

The IC697ACC621 is a fan tray assembly that works with the GE Series 90-70 PLC.
This particular fan tray provides an additional rack cooling system with two fans per assembly. The rack fan is easily installed as an accessory with the five slot and PACSystems RX7i nine-slot racks. The IC697ACC621 is ideal for systems where heat build-up is a potential problem. The system offers a low noise level and uses ball bearings for an extended life span. The manufacturer does recommend that the fans be wired to the same power source as the PLC as this will ensure the fans run each time the PLC is actively in use.

To wire the fans, use the parallel cable assembly supplied with the fan, which is located on the back of the fan assembly. The IC697ACC621 fan tray is compatible with the IC697CHS750, IC698CHS009, and IC697CHS109 racks. When mounted on the rack, the unit is located on the bottom to allow the air to flow from the bottom to the top of the rack for cooling.

Easy installation is completed with only a #2 Phillips head screwdriver. A minimum of 9 inches of space is needed between racks to remove each individual fan and can be accomplished by removing the three screws from the front lower panel of the rack. Simply position the fan assembly on the bottom rack, and slide the flange on the rear of the assembly. Align the holes, reinstall, and tighten the screws. Each fan has a replaceable polyurethane filter that can be cleaned between replacements if needed.

GE 115VAC fan tray to be used with Series 90-70 or RX7i short racks.
ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

Common related search terms: DatasheetManualPDFPLCPriceRepairSpecificationTroubleshootUser-ManualWiring

PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.