GE / IP FANUC Series 90/30 In Stock
The IC697ACC621 is a fan tray assembly that works with the GE Series 90-70 PLC. This particular fan tray provides an additional rack cooling system with two fans per assembly. The rack fan is easily installed as an accessory with the five slot and PACSystems RX7i nine-slot racks. The IC697ACC621 is ideal for systems where heat build-up is a potential problem. The system offers a low noise level and uses ball bearings for an extended life span. The manufacturer does recommend that the fans be wired to the same power source as the PLC as this will ensure the fans run each time the PLC is actively in use.
To wire the fans, use the parallel cable assembly supplied with the fan, which is located on the back of the fan assembly. The IC697ACC621 fan tray is compatible with the IC697CHS750, IC698CHS009, and IC697CHS109 racks. When mounted on the rack, the unit is located on the bottom to allow the air to flow from the bottom to the top of the rack for cooling.
Easy installation is completed with only a #2 Phillips head screwdriver. A minimum of 9 inches of space is needed between racks to remove each individual fan and can be accomplished by removing the three screws from the front lower panel of the rack. Simply position the fan assembly on the bottom rack, and slide the flange on the rear of the assembly. Align the holes, reinstall, and tighten the screws. Each fan has a replaceable polyurethane filter that can be cleaned between replacements if needed.