1-919-535-3180 | 1-800-360-6802

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i



Mon-Fri 8AM-5PM EST



Rated 4/5 Based on 5 ratings.

Rate your purchase of the IC697ACC702

GE Intelligent Platforms / GE Fanuc - Series 90-70 - IC697ACC702

SKU 0  UPC 00

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.

MSRP $190

"Avg. Repair - 2 Days"

Repair Service


Save $91

5-10 Days

✓  2 Year PDF Supply warranty

*What is Fast Repair?

Product Description 

The IC697ACC702 is a GE I/O Bus Terminator Plug specific to the GE Fanuc Series 90-70.
This bus terminator plug is typically supplied with each bus receiver module and is only required in the last bus receiver module in the chain. If the bus expansion module is not at the end of the chain, the terminator plug may be saved as extra or discarded depending on user preference. If the bus receiver module is at the end of the chain, then the terminator plug is required for the unit.

The terminator plug should be installed in the lower expansion port labeled as Expansion Port Out. The plug can then be attached with the included screws. In a standard PLC system, this is accomplished by installing the resistor pack that is located inside of a terminator plug. In a hot standby CPU redundancy system, a special I/O cable is required. This has a built-in termination system. The manufacturer does recommend the use of a resistor plug with the terminated cable.

When installing the IC697ACC702, the user must make sure the power to the unit is OFF and proper guidelines are followed per the manual. This particular I/O bus terminator plug is compatible with the GE Series 90-30 module and is required for each local expansion pack. The middle LED indicates the presence of a terminator plug on compatible models. Both conformal coat and low temperature testing options are available by special order.

GE I/O Bus Terminator Plug
ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

Common related search terms: DatasheetEmersonManualPDFPLCPriceRepairSpecificationTroubleshootUser-ManualWiring

All online orders placed before 4:30 PM EST “SHIPS SAME DAY FREE!" World’s largest warehouse of Factory Sealed GE 90-30 PLC, GENIUS I/O and RX7i PACSystem.highlight_off

PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.