GE / IP FANUC Series 90/30 In Stock
SKU 2177439 UPC 0799705792739
All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.
Made by GE Automation and Controls, the IC697CPU780 is a single-slot PLC CPU capable of controlling machinery and processes in real-time. Communication with I/O and “smart option” modules is accomplished via a rack-mounted connection backplane. To control and operate this PLC, use the built-in control switch or connect the device to a computer.
The IC697CPU780 has a 16MHz 80386DX microprocessor which can support floating point calculations every 0.4 microseconds. Up to 8K analog I/O is supported, along with various mixes of 12K inputs and outputs. This device supports several modules, including the following: IC697 LAN interface modules, bus controllers for IC660 and IC661, and discrete and analog IC697 I/O modules.
The IC697CPU780 also supports Hot Standby redundancy applications. A variety of redundancy features are also included such as CPU synchronization, “bumpless switching,” 20ms scan extension, and no single point of failure.
Up to 512 kilobytes of user and program memory is provided by an expansion board. Memory is maintained by a CMOS battery. The memory expansion board also supports up to 256 kilobytes of flash memory (NVRAM). Error checking is provided by a checksum routine with parity detection.
The IC697CPU780 is configured by IC641 software running from an attached MS-DOS programmer computer. There are no DIP switches or jumpers required to program this device. To connect the device to the programmer computer, use either a serial or parallel connection. To protect configuration settings, use either the built-in memory protection switch or a software password.
Follow the guidelines in the product’s manual during installation. Disable power to the rack. Put the control switch into the stop position. Put the memory protection switch into the off position. Connect the memory board to the device. Put the CMOS battery into one of the on-board battery slots. Install the device into the first slot of the rack and enable power to the rack.
|Module Type:||Hot Standby CPU|
|Number of Slots:||1 (Single slot)|
|Current Required:||1.6 Amps|
|Number of Points:||12K inputs and outputs (any mix)|
|Supports:||IC660/IC661 I/O and IC697 I/O|
PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.