GE / IP FANUC Series 90/30 In Stock
SKU 2172039 UPC 0799705792753
All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.
The "CA" Revision is for the PDF Supply Conformal Coating Service. PDF Supply warranty will apply. A $150 service charge will be added at checkout.
The IC697CPU782 is a Programmable Logic Controller designed to fit into a single rack slot. It is capable of controlling machinery and material handling systems in real-time. A rack-mounted backplane gives this device the ability to communicate with various I/O modules. To operate and control this device, use the run/stop control switch or a connected computer with the corresponding software. The IC697CPU782 has a 16MHz microprocessor with the ability to perform floating point calculations at performance speeds of 0.4 microseconds. This device can process various mixtures of up to 12K inputs and outputs and 8K analog I/O.
The IC697CPU782 requires a memory expansion board to store user data and program information. This expansion board provides up to 512 KB of volatile memory and 256 KB of flash memory. Volatile memory is maintained by a CMOS RAM battery. To install this expansion board, the CPU must first be initialized by a connected computer. IC697 LAN interface modules, IC660 and IC661 bus controllers, numerous coprocessor modules, various communications modules, and all discrete and analog I/O modules from the IC697 family are compatible with the IC697CPU782.
This device is configured by software running from a programmer computer. DIP switches and jumpers are not necessary for programming. Configuration is possible via serial or parallel interface. An Ethernet connection is also possible if the proper hardware is installed. Either MS-DOS or a Windows 95 and Windows NT computer running appropriate software is needed to program the IC697CPU782. A password protects the configuration settings along with a built-in memory protect key switch.
Detailed instructions for installing the IC697CPU782 can be found in the device manual. Disconnect power from the rack before attempting to install. Set the memory key switch in the off position. The run/stop switch should be in the stop position. Connect the memory expansion board. The CMOS RAM battery can be placed into either connector. Insert the IC697CPU782 into the rack, and power it on.
|Module Type:||Expandable, Floating Point CPU|
|Number of Slots:||1 (Single slot)|
|Current Required:||1.6 Amps|
|Number of Points:||12K inputs and outputs (any mix)|
|Supports:||IC660/IC661 I/O and IC697 I/O|
PDF Electric & Supply Inc. sells new, new surplus and refurbished products which are sourced through independent channels. All warranties and support, if applicable, are with PDF Electric & Supply Inc. and not the manufacturer. PDF Electric & Supply Inc. is not an authorized distributor or representative for the listed manufacturers and makes no representations as to any quality control performed by any listed manufacturer on the products. The products listed on this website may vary as to their country of origin; the accessories, and other items included with the product; and the language used on the packaging, the parts, and any related instructions or printed material related to the products. This website is not sanctioned or approved by any manufacturer or tradename listed. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.